EVOQUEFIT · GARAGE ESSENTIALS
Put the injector in control of your next test.
Pulse an injector individually instead of guessing where a fueling issue begins. A compact control unit brings selectable output and a clear mode display to your garage setup.
A focused test, one injector at a time.
- Four pulse patterns: single, short, long and continuous output.
- 12V battery powered: connect the supplied battery clips to a suitable power source.
- Mode display: see the selected setting while you work.
- Repeatable comparisons: keep the same settings when comparing compatible injectors.
Use it as part of your diagnostic setup
The tester supplies electrical pulses. Fluid delivery and spray observation require a suitable separate cleaning or test setup. It does not contain a cleaning pump or replace a complete injector test bench.
Before connecting
- Check injector type, connector and electrical requirements against the tool instructions.
- Switch off the engine, relieve fuel pressure as specified by the vehicle maker and isolate the injector.
- Connect the tester with the correct polarity and select the appropriate mode.
- Run a controlled test, compare results and disconnect the power before changing connections.
Kit details
| Power input | 12V vehicle battery |
|---|---|
| Pulse patterns | Single / short / long / continuous |
| Control unit size | Approx. 11.8 × 8 × 2.5 cm |
| Included | Tester with battery leads, injector connection leads and cleaning adapters shown |
Check compatibility first
Check the connector and injector specification before purchase. Do not assume compatibility with diesel common-rail, direct-injection or piezo injectors. Batteries, injectors, cleaning fluid and the cleaning machine in application images are not included.
Work in a ventilated area away from sparks and ignition sources. Follow vehicle service instructions when handling fuel and use suitable eye protection.